We offer you all our skills for the repair of your damaged and cracked floors.
For more than 30 years, we have been facing challenges of competitiveness, quality and deadlines that allow us to be recognized and esteemed in the industrial, food and logistics sectors._cc781905-5cde-3194- bb3b-136bad5cf58d_
Our fast-setting resins and resin mortars considerably reduce the downtime of the areas concerned and undeniably facilitates the return to service of your operation.
Our engagement :
Respond effectively and quickly to your floor problems thanks to our competent teams, in order to respect the safety standards of your staff, the use of your equipment and thus avoid excessive wear of the wheels.
Restore the optimal use of your soils.
They are injected when their openings and depths allow it.
When the opening of the crack does not allow it, it is necessary to proceed differently: the crack must be sawn on both sides then broken and repaired with epoxy resin mortar.
The broken cracks
If the contraction, construction or expansion joints have not been maintained over the years, they deteriorate with the passage of forklifts. When it is no longer possible to repair them by filling, they must then be sawed on both sides, the concrete broken and the joint reconstituted with epoxy resin mortar.
Spalled joints
The cracks
injected
Two adjoining paving panels can sometimes alternately sag as trolleys pass, creating a so-called "striking" phenomenon, which is very damaging to joints or cracks. In order to treat these two pathologies, it is necessary either to inject a grout on the underside of the concrete, or to interpose a metal part to block this phenomenon.
Drumming
Sometimes it happens that the concrete is too broken and it is no longer possible to repair it with the above conventional methods.
It is then necessary to saw the slab over its entire thickness, evacuate the defective concrete and recast High Performance concrete. This also applies to sagging gaze pads. (below: before/after)
Avant _cc781905-5cde-3194 -bb3b-136bad5cf58d_ / after
Les
collapses
Wear layers (quartz, corundum, etc.) sometimes sound hollow. If we leave the difficult task of finding out the cause to the engineers and experts, we can, by injection, re-glue a loose wear layer.
Avant _cc781905-5cde-3194 -bb3b-136bad5cf58d_ / after
Bonding of a wear layer
